Trigger/Macro example - Relock Door and Deactivate Outputs on a Push Button | IMRON Corporation- UnityIS Knowledge Base

Note: this applies to Azure IC2 only

Trigger Event: MonitorPoint InActive

Trigger Condition: while Trigger Variable X = ON and Trigger Variable Y = ON

Execute Macro: add the following commands

Command: Set Trigger Variable	Address: 2.0	Properties: 1 0
Command: Control Point: Deactivate	Address: 2.0.0.O2: Door Sounder 2	Properties:
Command: Reader Mode: Card or PIN	Address: 2.0.0.R1: Reader 1	Properties:
Command: Set Trigger Variable	Address: 2.0	Properties: 2 0