The Azure IC2 with PoE can provide power to all peripheral devices (Reader, door lock). This eliminates the need to have a power supply which allows the controller to be placed on areas otherwise not possible.
Be sure to do power calculations and verify they do not exceed the limits of the IC2 controller.
To enable PoE on the controller, enable jumper 'J1'.
If you will be using the auxiliary power from the IC2 to power the door locks, you will need to do the following:
Connect a wire from the 'VOUT' PIN on TB2 to the common PIN ('C') on TB10. Then connect a wire from the common ('C') PIN on TB10 to the common ('C') PIN on TB9. This will provide 12V of power to both of these relays.
Below is a wiring diagram using the UnityIS default door mapping with door strikes:
